Fifth Class Meeting - Timothy Felix Vickary
RESUME
We need to utilize structural software as mechanical engineers cover the building concept and leads to the decision of piping system, cooling system etc which consist inside the building.
Theorem is produced from axioms and become law. This case occurs because we believe on mathematics as exact knowledge, and mathematics could solve or proof problems.
Early approach by using continuation concept, object is considered to have continuing characteristic. From there, mathematical modelling is developed. It goes to navier stokes equation, that mathematical equation is for fluid flow prediction based on momentum and mass. Likewise, software, if we consider object to have rigid body which particle could inter-react one another.
We then need to start questioning what force to be inputted and what the result is yielded from simulation. We are not only learning formulas, but the foremost is how to use and apply them. “Economy will be outdated as it chases big profit from small amount of worked” -DAI-
The talk then derails to truss characteristic which is about stress acting on the member. It can be elaborated such as:
1. Simple or Direct stress
a. Tension
b. compression
c. shear
simple tension and simple compression occur when applied force (load) is linear with the axis of member and simple shear occurs when equal, parallel and opposite forces tend to cause a surface slide relative to adjacent surface.
2. Indirect stress:
a. Bending
b. Torsion
In certain loading situations, stresses cause the member to bend resulting in deformation of material such stresses are called indirect stresses.
3. Combined stress: Any possible combination of direct and indirect stresses.
While the strain is deformation produced by stresswhich can further be classified into 4 type of strain:
- Tensile strain: strain caused by tensional stress ie ratio of increase in length to actual length
- Compressive strain: strain caused due to compressive stress, it means ratio of decrease in length to actual length
- Shear strain: in case of shearing load shear strain will be produced which is measured by an angle through which the body deforms
- Volumetric strain: it is ration between change in volume and original volume of the body
Differentiation is required to solve one big system which is divides to small part therefore small changes and characteristic from one particular part can be seen. As we need for example to figure out stress and strain from one section of truss from 3 dimension of x y z, differentiation becomes necessary to show critical point and location hence engineers could determine which material and shape to be used.
- What types of mathematical modelling is used in SAP2000 or Frame 3DD?
- How does the software check error and yield range of estimated value?
- Can both software simulates disaster such as fire regarding extreme temperature changes, floods regarding uncertain loads, and so on?
- How does the software simplify the model?
ASSIGNMENT
As the advancement of the software, the skill and proficiency of using it to model, simulate, and analyse is necessary. Practical example is building, as it needs structure to support the mass, it requires thorough assessment to ensure the structure capable on handling and guarantee the safety objects inside the building according to the design and prevailing provision. Frame 3DD is one of a freeware anybody can utilize to simulate structure by inputting structural and environment data imposed on the building to simulate and visualize the phenomena. The accuracy and precision of the software in ideal condition produce remarkable result but engineer as decision maker needs the basis knowledge to give the best decision. Verification and validation are also necessary to improve the result to yield unanimous decision among the engineers.
Students have the capability to predict and measure the probable model of a simple roofing structure to be built and analyse the output.
Designing the simple roof model, determine nodes and frame to be simulated. For this assignment, Tri-Bearing type of roof is used. The model can be seen below.
Or in simple figure
The model will be arranged backward to be as near as the real system.
